Seamless Rigging

Seamless Rigging’s Fully Stowless Main Deployment Bag Directions

1. Have your new bag installed by the person jumping the rig or by a parachute rigger.
2. Pack your main as normal. Before beginning to place in the bag make sure the extended flap of your new bag is placed on the floor and the opening is facing you. At this point the attached magnetic top flap should be facing the sky. Open your top flap so that you can see the pocket created.
3. Insert your main into the bag. With the top flap open so that you can see the webbing holding the magnets; grab the extended flap that is on the ground and enclose the bag. This flap will be the middle set of magnets when finished. IT MUST BE THE MIDDLE SET OF MAGNETS WHEN FINISHED!! At this point the top flap should still be open and the structure of the bag should be enclosing the main parachute. The bag should remain closed. If these two sets of magnets do not hold closed; your parachute is too large for the bag.
4. The lines to your main parachute should be centered in the 2” channel created, now facing towards the top pocket.
5. S-fold your lines in the pocket. I recommend two full passes in the pocket below the bartacks, the rest between the bartacks and magnetic closures.
6. Leave an appropriate amount for you parachute 18”+ depending on your model.
7. Place into your main parachute tray per container manufacturer’s instructions rotating the bag so that the top grommet is facing towards the reserve, and the magnetic closure is on top. The magnetic closure should now be on top facing the packer; towards the lower portion of the tray. Any questions contact Seamless Rigging at [email protected] prior to your jump.
8. Close container per manufacturer’s instructions. WARNING:
Skydiving in dangerous. Having no control over the use of these products, we assume no liability connected with their use. Under no circumstances are we liable for any loss, damage or expenses of any kind arising out of the use or inability to use our products.